MOTOUSA.com AND JETT TUNING PICK UP 14.8 PEAK HP WITH THE HELP OF MR12!
Our friends at MotorcycleUSA.com and Jett Tuning (a Southern California-based motorcycle performance shop) witnessed some huge power gains on their 2012 Honda CBR600RR Project Bike after installing a handful of aftermarket performance parts, filling the tank with VP MR12 and then completing a dyno and tune:
"Ethell spent about 2.5 hours on his in-house Dynojet 250i dynamometer creating a map for the Yosh pipe as well as the type of race fuel we were going to race on (VP Racing Fuels MR12). All said and done Ethel was able to extract 14.8 additional peak horsepower (119.03 total) at 14,100 rpm (1300 higher as compared to stock). Peak torque was also increased by 2.76 lb-ft at 11,500 rpm (300 higher than stock). While more top-end power is always good what’s really impressive is the increase in horsepower and torque throughout the powerband once the engine is spinning over 5000 revs. Also of note is the big improvement in over-rev with the engine pulling longer and harder before the rev-limiter shuts the engine down at 15,500 rpm."
CLICK HERE TO READ MORE
Posted by VP RACE FOOL on 12th November, 2012 | Comments | Trackbacks
Tags: POWERSPORTS, MOTOUSA.com, HONDA, CBR600RR, JETT TUNING, MR12, SUPERBIKES, PROJECT BIKE
The trackback URL for this page is http://www.vpracingfuels.com/trackback?post=26449739
Trackbacks
There are no trackbacks for this post
There are no comments for this post
Post a Comment
HTML is not allowed in comments, http://... will be automatically linked.
